Advisory

GHSA-77x9-rf64-92gv

Also known as: CVE-2026-42081, GO-2026-5209

Summary

Free5GC AMF Bypasses UE Security Capabilities on NGAP PathSwitchRequest

Details

Summary
The AMF in Free5GC v4.2.1 does not verify the UE Security Capabilities received in NGAP PathSwitchRequest messages against its locally stored values, as mandated by 3GPP TS 33.501 §6.7.3.1. A malicious gNB can overwrite the AMF's stored UE security capabilities with arbitrary values, which are then propagated in PathSwitchRequest Acknowledge messages and subsequent Handover Request messages. This leads to persistent handover denial-of-service for affected UEs.

Details
Affected File: amf/internal/ngap/handler.go — handlePathSwitchRequestMain function

Root Cause:

When the AMF receives a PathSwitchRequest during an Xn-handover, it processes the UESecurityCapabilities IE by directly overwriting the stored values without comparing them to the previously stored capabilities:

if uESecurityCapabilities != nil {
    amfUe.UESecurityCapability.SetEA1_128_5G(uESecurityCapabilities.NRencryptionAlgorithms.Value.Bytes[0] & 0x80)
    amfUe.UESecurityCapability.SetEA2_128_5G(uESecurityCapabilities.NRencryptionAlgorithms.Value.Bytes[0] & 0x40)
    amfUe.UESecurityCapability.SetEA3_128_5G(uESecurityCapabilities.NRencryptionAlgorithms.Value.Bytes[0] & 0x20)
    amfUe.UESecurityCapability.SetIA1_128_5G(uESecurityCapabilities.NRintegrityProtectionAlgorithms.Value.Bytes[0] & 0x80)
    amfUe.UESecurityCapability.SetIA2_128_5G(uESecurityCapabilities.NRintegrityProtectionAlgorithms.Value.Bytes[0] & 0x40)
    amfUe.UESecurityCapability.SetIA3_128_5G(uESecurityCapabilities.NRintegrityProtectionAlgorithms.Value.Bytes[0] & 0x20)
}

3GPP TS 33.501 §6.7.3.1 requires three actions, none of which are implemented:

  1. Verification (SHALL): "The AMF shall verify that the UE's 5G security capabilities received from the target gNB/ng-eNB are the same as the UE's 5G security capabilities that the AMF has locally stored." → Not implemented. The AMF unconditionally overwrites stored values.
  1. Correction (SHALL): "If there is a mismatch, the AMF shall send its locally stored 5G security capabilities of the UE to the target gNB/ng-eNB in the Path-Switch Acknowledge message." → Not implemented. The PathSwitchRequestAcknowledge contains the corrupted values.
  1. Logging (SHALL): "The AMF shall support logging capabilities for this event and may take additional measures, such as raising an alarm." → Not implemented. No mismatch detection or logging exists.

Propagation:

The corrupted values are propagated in:

  • PathSwitchRequestAcknowledge: Contains corrupted UESecurityCapabilities (demonstrated in pcap)
  • Subsequent HandoverRequest messages: AMF sends corrupted capabilities to target gNBs

Per TS 38.413 §8.4.2.4, if the supported algorithms in the UE Security Capabilities do not match any allowed algorithms configured in the target gNB, the target gNB is required to reject the procedure using a HANDOVER FAILURE message.

PoC
Environment:

  • Free5GC v4.2.1 AMF (Docker container) with full NF stack (NRF, AUSF, UDM, UDR, NSSF, PCF, SMF, UPF)
  • UERANSIM v3.2.7 gNB with custom inspection-tool extension
  • tshark for packet capture

Reproduction Steps:

  1. Start Free5GC full stack and register a UE through a gNB (NG Setup → Registration → PDU Session Setup).
  1. Send a normal HandoverRequired from the gNB. Capture the resulting HandoverRequest from the AMF and confirm nRintegrityProtectionAlgorithms = 0xe000 (NIA1, NIA2, NIA3 all supported). This is the baseline.
  1. Send a PathSwitchRequest with nRintegrityProtectionAlgorithms = 0x0000 (all integrity algorithms set to not supported). The AMF responds with PathSwitchRequestAcknowledge.
  1. Observe that the PathSwitchRequestAcknowledge contains nRintegrityProtectionAlgorithms = 0x0000 — the corrupted values are propagated back.

Observed Result (from pcap capture):

| Packet | Message | nRintegrityProtectionAlgorithms |
|--------|---------|-------------------------------|
| #20 | HandoverRequest (AMF→gNB) | 0xe000 (NIA1 ✓ NIA2 ✓ NIA3 ✓) — baseline |
| #30 | PathSwitchRequest (gNB→AMF) | 0x0000 — poison |
| #47 | PathSwitchRequestAcknowledge (AMF→gNB) | 0x0000 (NIA1 ✗ NIA2 ✗ NIA3 ✗) — corrupted |

Impact
Availability (HIGH): A malicious gNB can send a single PathSwitchRequest message to corrupt the AMF's stored UE security capabilities for any UE. All subsequent inter-gNB handovers for the affected UE are expected to fail (per TS 38.413 §8.4.2.4), resulting in denial-of-service that persists until the UE performs a new registration.

Integrity (LOW): The AMF's internal UE security context is corrupted with attacker-controlled values. These corrupted values are propagated to other network elements via PathSwitchRequestAcknowledge and HandoverRequest messages.

Who is impacted: Any deployment using Free5GC as the AMF where a gNB could be compromised or where untrusted gNBs exist (e.g., O-RAN multi-vendor deployments).

Severity

Medium Basis: The source's own band: MODERATE

Dates

Published
2026-05-07 01:53 UTC
Modified
2026-06-25 19:56 UTC

Affected packages and fixes

github.com/free5gc/amf

Go · All systems

Affected

  • introduced 0, last affected 1.4.3 (semver)

Fixed versions

None listed

Fix

No fixed version is listed.

Fix commands are the export's own generic commands. Ojuju never runs them. Check them against your setup first.

Check your own computer: guard packages check

View this record on OSV.dev

Source

Source: GitHub Advisory Database (reviewed advisories) · CC BY 4.0

Sources & licences